D9412GV4/D7412GV4/D7212GV4 Keypad Tools Menu (Options Not Available in RPS) | en 205
Bosch Security Systems, Inc. Program Entry Guide F.01U.218.312 | 04 | 2012.03
3. The number of points in service bypass display below the Point Num 1-247: prompt.
Enter the point number followed by [ENTER] or press the Next softkey to advance to the
point.
4. At the Point (###) Service Bypass: Yes prompt press the Edit softkey.
5. Press the No softkey, then press the Save softkey to remove service bypass.
6. Press the Next softkey to advance to another point, or press the Exit softkey to select
another, or press the Esc softkey to exit
When the keypad reads Parameter Saved, your selection has been configured.
11.2 RF Points Menu
11.2.1 Enroll RF Point
D1255
1. Refer to Section 2.5.1 Keypad Programming Menu, page 12 to access the TOOLS MENU
and navigate to the RF POINTS option.
2. Press [ENT] to enter the RF POINTS option.
3. At the ENROLL RF POINT prompt, press the [ENT] option. If all wireless devices are
enrolled, ALL POINTS ADDED shows. If wireless devices are available for enrolling, a list
of wireless devices shows.
4. To scroll through the available devices to enroll, press [NEXT], and then press [ENT]
when the desired device shows.
5. The keypad indicates a transmission to the device. Press the [RESET] button on the
device to enroll it. The keypad reads POINT ENROLLED.
D1260
1. Refer to Section 2.5.1 Keypad Programming Menu, page 12 to access the TOOLS MENU
and navigate to the RF POINTS option.
2. Press [ENTER] to enter the RF POINTS option.
3. At the Enroll RF Point prompt, press the [ENTER] option. If all wireless devices are
enrolled, All Points Added shows. If wireless devices are available for enrolling, a list of
wireless devices shows.
4. To scroll through the available devices to enroll, press the Next softkey, and then press
[ENTER] when the desired device shows.
5. The keypad indicates a transmission to the device. Press the [RESET] button on the
device to enroll it. The keypad reads Point Enrolled.
11.2.2 Replace RF Point
D1255
1. Refer to Section 2.5.1 Keypad Programming Menu, page 12 to access the TOOLS MENU
and navigate to the RF POINTS option.
2. Press [ENT] to enter the RF POINTS option.
3. At the REPLACE RF POINT prompt, press [ENT]. A list of enrolled wireless devices
shows.
4. To scroll through the available devices to replace, press [NEXT], and then press [ENTER]
when the RF point you wish to replace shows.
5. If wireless devices are available for enrolling as a replacement, a list of wireless devices
shows. To scroll through the available devices to enroll, press [NEXT], and then press
[ENT] when the desired device shows.
6. The keypad indicates a transmission to the device. Press the [RESET] button on the
device to enroll it. The keypad reads POINT ENROLLED.
To Next Page
Loading...
