206 en | Keypad Tools Menu (Options Not Available in RPS) D9412GV4/D7412GV4/D7212GV4
F.01U.218.312 | 04 | 2012.03 Program Entry Guide Bosch Security Systems, Inc.
D1260
1. Refer to Section 2.5.1 Keypad Programming Menu, page 12 to access the Tools Menu and
navigate to the RF Points option.
2. Press [ENTER] to enter the RF Points option.
3. At the REPLACE RF POINT prompt, press [ENTER]. A list of enrolled wireless devices
shows.
4. To scroll through the available devices to replace, press the Next softkey, and then press
[ENTER] when the RF point you wish to replace shows.
5. If wireless devices are available for enrolling as a replacement, a list of wireless devices
shows. To scroll through the available devices to enroll, press the Next softkey, and then
press [ENTER] when the desired device shows.
6. The keypad indicates a transmission to the device. Press the [RESET] button on the
device to enroll it. The keypad reads Point Enrolled.
11.2.3 Remove RF Point
D1255
1. Refer to Section 2.5.1 Keypad Programming Menu, page 12 to access the TOOLS MENU
and navigate to the RF POINTS option.
2. Press [ENT] to enter the RF POINTS option.
3. At the REMOVE RF POINTS prompt, press [ENT]. A list of enrolled wireless devices
shows.
4. At the following prompt (PT-## RFID AUTO LEARNED if the previous device was auto-
learned, or PT-## and then the RFID) prompt, enter in the RF point number you wish to
remove and press [ENT] or to scroll through the available devices to enroll, press [NEXT],
and then press [ENT] when the desired device shows. The keypad reads RF POINT
REMOVED.
D1260
1. Refer to Section 2.5.1 Keypad Programming Menu, page 12 to access the Tools Menu and
navigate to the RF Points option.
2. Press [ENT] to enter the RF Points option.
3. At the Remove RF Points prompt, press [ENTER]. A list of enrolled wireless devices
shows.
4. At the following prompt (PT-## RFID Auto Learned) if the previous device was auto-
learned, or PT-## and then the RFID) prompt,, enter in the RF point number you wish to
remove and press [ENTER] or to scroll through the available devices to enroll, press the
Next softkey, and then press [ENTER] when the desired device shows. The keypad reads
RF Point Removed.
NOTICE!
By pressing the [ENT] button inside the REMOVE RF POINT option, you will remove any
previously programmed points, and an alarm will go off. A NO POINTS prompt will be
displayed as a result.
NOTICE!
By pressing the [Remove] button inside the Remove RF Point option, you will remove any
previously programmed points, and an alarm will go off. A No Points prompt will be displayed
as a result.
To Next Page
Loading...
