198 en | ACCESS CONTROL (D9412GV4/D7412GV4) D9412GV4/D7412GV4/D7212GV4
F.01U.218.312 | 04 | 2012.03 Program Entry Guide Bosch Security Systems, Inc.
prompt programmed as Yes when a Fire Alarm occurs in any area. Relays that are activated by
Fire Unlock can be returned to normal only through the keypad using the Door Control
function.
D# Disarm on Open?
Use this program item to determine if the door needs to be physically opened before
disarming the area upon a valid access request. The user initiating the access request needs
access levels that allow disarming with ID.
D# Card Type
This item must be kept to a value of 0 (26 bit Wiegand format).
9.2 Strike Profile
This programming category is used to create a specific door profile for:
– Strike and shunt times.
– Extending strike and shunt times if a door is left open.
– Resetting the strike when the door opens.
D# Strike Time
Enter the amount of time the door controller toggles the relay output to activate the door
strike. When the door strike is activated, the user can open the door. The strike activates for a
valid token, RTE, REX, and the keypad CYCLE DOOR? function.
NOTICE!
Doors that are activated by Fire Unlock must be returned to normal using the Door Control
function on the keypad.
CAUTION!
This command unlocks the door regardless of the armed state.
NOTICE!
Each fire alarm that is generated causes a Door Unlocked – Automatic Event.
Default: Yes
Selection: Yes or No
Yes The area disarms only after the door is opened for a user with a valid
disarm level.
No The area disarms whether or not the door is opened as soon as a user
with a valid disarm level presents a valid token or card. If D# Door Point
is set to 0, then this prompt is treated as if it were set to No.
Default: 0
Selection: 0 to 3
0 Card format is 26-bit Wiegand.
3 Do not use. Card format is 37-bit fidelity.
Default: 10 sec
Selection: 1 sec to 240 sec
0 Strike Time is not programmed for this door.
1 to 240 The strike activates for the amount of time programmed.
To Next Page
Loading...
