Bosch D7412GV4 - IP Diagnostics Keypad Menu (B420)

D9412GV4/D7412GV4/D7212GV4 SDI2 Modules | en 189
Bosch Security Systems, Inc. Program Entry Guide F.01U.218.312 | 04 | 2012.03
8.3.1 IP Diagnostics Keypad Menu (B420)
Settings
D1255
1. Refer to Section 2.5.6 IP Diagnostics Menu, page 16 to access the TOOLS MENU and
navigate to the IP DIAGNOSTICS option.
2. Press [ENT] to enter the IP DIAGNOSTICS option.
3. At the B420 MOD 1-2 option, enter the number for the B420 module for which you want
to review the settings, and press [ENT].
4. Press [ENT] at the SETTINGS option. The keypad shows the Hostname.
5. Press [NEXT]. The keypad shows the MAC ID.
6. Press [NEXT]. The keypad shows the current IP address assigned to the module.
7. Press [ESC] when finished reviewing the settings.
D1260
1. Refer to Section 2.5.6 IP Diagnostics Menu, page 16 to access the Tools Menu and
navigate to the IP Diagnostics option.
2. Press the corresponding soft button to enter the IP Diagnostics option.
3. At the B420 Module 1-2 option, enter the number for the B420 module for which you
want to review the settings, and press [ENTER].
4. Press [ENTER] at the Settings option. The keypad shows the Hostname.
5. Press the Next soft button. The keypad shows the MAC ID.
6. Press the Next soft button. The keypad shows the address assigned to the module.
7. Press the Exit soft button when finished reviewing the settings.
Connection Test
D1255
1. Refer to Section 2.5.6 IP Diagnostics Menu, page 16 to access the TOOLS MENU and
navigate to the IP DIAGNOSTICS option.
2. Press [ENT] to enter the IP DIAGNOSTICS option.
3. At the B420 MOD 1-2 option, enter the number for the B420 module for which you want
to review the settings, and press [ENT].
4. Press [ENT] at the CONNECTION TEST option. The keypad tests and shows the results
for:
– Link. Tests the network cable connection, and responds with OK or FAILURE.
– Gateway. Tests the connection to the gateway, and responds with OK or FAILURE.
– Internet. Tests the network cable connection, and responds with OK or FAILURE.
D1260
1. Refer to Section 2.5.6 IP Diagnostics Menu, page 16 to access the TOOLS MENU and
navigate to the IP DIAGNOSTICS option.
2. Press the corresponding soft button to enter the IP Diagnostics option.
3. At the B420 Module 1-2 option, enter the number for the B420 module for which you
want to review the settings, and press [ENTER].
NOTICE!
You must configure an IP Test Address in RPS to test the Internet function. If the IP Test
Address is not configured, the Internet test results in failure. Refer to Section IP Test Address,
page 188.