Bosch D7412GV4 - Access Control Functions

96 en | Panel and Area Wide Parameters D9412GV4/D7412GV4/D7212GV4
F.01U.218.312 | 04 | 2012.03 Program Entry Guide Bosch Security Systems, Inc.
View Memory
Use this function to view prior alarm, trouble, and supervisory activity occurring since the last
time the system armed. Event memory is not cleared until the area re-arms.
View Point Status
Use this function to view points assigned to the area where the keypad is assigned. This
function shows point text and the electrical condition (normal, open, short, and missing) of
each point in the area.
Walk Test
Use this function to test Controlled points in areas within the keypad’s scope without sending
reports to the central station. 24-hour points cannot be tested using this Walk Test Mode.
Fire Test
Use this function to test 24-hour points in areas within the scope of the keypad where the
function is entered. Controlled points, P## Type 1, 2, 3, cannot be tested using the Fire Walk
Test Mode.
Send Report
Use this function to test the communication link between the control panel and the central
station receiver(s). It can send a Test Report or a Status Report to the phone numbers
programmed in Routing. The Test Report includes additional information if Expand Test
Report is enabled in Section 3.1 Phone, page 17.
3.12.3 Access Control Functions
Door Control
Default: E
Selection: -, E, or P
Function No. Function Name Alternate Keystroke
9 View Event Memory [COMMAND][4][0]
Default: E
Selection: -, E, or P
Function No. Function Name Alternate Keystroke
10 View Point Status (Menu function only)
Default: E
Selection: -, E, or P
Function No. Function Name Alternate Keystroke
11 Walk Test [COMMAND][4][4]
Default: P
Selection: -, E, or P
Function No. Function Name Alternate Keystroke
12 Fire Test [COMMAND][5][8]
Default: E
Selection: -, E, or P
Function No. Function Name Alternate Keystroke
13 Send Report [COMMAND][4][1] or [COMMAND][4][2]
Default: P
Selection: -, E, or P