Bosch D7412GV4 - SIA Duress Passcode Options; Function List

116 en | Panel and Area Wide Parameters D9412GV4/D7412GV4/D7212GV4
F.01U.218.312 | 04 | 2012.03 Program Entry Guide Bosch Security Systems, Inc.
3.12.10 SIA Duress Passcode Options
USER INTERFACE>Authority Level>L## Disarm
USER INTERFACE>Authority Levels>L## Send Duress
USER INTERFACE>Authority Levels>L## Passcode Disarm
General Programming Information
User Authority Index 14 is programmed by default as a duress disarm profile. When Duress
Option is configured with a value of 3, the SIA CP-01 compliant Duress Passcode feature is
enabled. With Authority Index 14 assigned to a user passcode in an area, that user has the
authority to disarm and send a duress event from that area.
A Duress Disarm user authority index requires:
L## Disarm set to E
L## Send Duress set to E
L## Passcode Disarm set to E
For SIA CP-01 Compliance
Duress Types 1 and 2 (refer to Duress Type in Section 3.9 Miscellaneous, page 59) are not
allowed for use in SIA CP-01 compliant installations. All duress-capable passcodes must be
unique and cannot be derived from other passcodes. To facilitate this uniqueness, user
Authority Index 14 is preprogrammed from the factory as an example of duress disarm
authority.
3.13 Function List
The Function List is accessed when the user presses [MENU] (or the key corresponding to
menu on the D1260) while the keypad shows the idle text. Program as many as 32 M###
Function(s).
Each CC # keypad address can display a combination of any of the 32 menu items. The D1255
displays one menu item at a time. The D1260 displays up to two menu items at a time. Each
keypad address has one Function List. The function name shown in the Functions column in
the program record sheet appears in the keypad display in capital letters. For example,
WATCH MODE appears when you select #6 Watch Mode.
The M## Function displays items sequentially in the order they are programmed. The M1
Function is the first function that appears in the menu and M32 Function is the last function
that appears when scrolling through the menu.
M## Function
Enter the function number indicated in the “#” column of the program record sheet or next to
the function in Section 3.12 User Interface, page 93.
NOTICE!
Failing to program M## Function or M## CC Address 1..# causes COMMAND DISABLED to
appear in the keypad display.
Default: M1 through 15 are functions 1, 2, 29, 11, 15, 16, 17, 18, 19, 25, 26, 9,
10, 8, 21.M16 through M32 are 0.
Selection: 0 to 30, 32 to 37, and 128 to 143 (131 on D7412GV4 and D7212GV4)
NOTICE!
Function numbers 128 to 143 are custom functions and show the text programmed for CF ###
Text.