30 en | Panel and Area Wide Parameters D9412GV4/D7412GV4/D7212GV4
F.01U.218.312 | 04 | 2012.03 Program Entry Guide Bosch Security Systems, Inc.
RG# Same Network Receiver
For Example: This would be used when a DX4020 is reporting to a receiver over a LAN/ WAN
and a ITS-DX4020-G is reporting to the same receiver over the Internet from the cellular
service provider. This configuration also typically has the poll rate for the ITS-DX4020-G set to
a slower poll rate than the primary such as every 4 hours.
3.3.9 Communication Attempts
The control panel makes up to ten communication attempts using the primary and backup
devices within a route group. If unsuccessful, it sends a Comm Fail Report. The
communication attempts occur in the following sequence:
1. Primary device
2. Primary device
3. Backup device
4. Backup device
5. Primary device
6. Backup device
7. Primary device
8. Backup device
9. Primary device
10. Backup device
When only one destination is programmed, the control panel makes ten attempts to contact
that destination. When reporting via phone, each group takes approximately 10 min to go into
Comm Fail.
There are four Route Groups which contain a selection of event categorizes and individual
events. Each group has a primary and a backup device. The primary device is the first (most
important) destination used to reach the programmed route within this group. The backup
device is used if the primary device fails.
R# Primary Device
Default Yes
Selection: Yes or No
Yes The control panel uses the same authentication keys to communicate
with both the primary and backup paths that are the same receiver and
upon detection of a Communication Trouble on either the primary or
backup enhanced communication paths, the working path immediately
changes to the faster poll rate.
No The control panel uses separate authentication keys to communicate
with the primary and backup receivers and upon detection of a
Communication Trouble on either the primary or backup enhanced
communication paths, the working path continues to use its configured
poll rate.
NOTICE!
In the above example, if there is a Communication Trouble Condition on the DX4020, then the
ITS-DX4020-G will poll at the configured poll rate of the DX4020. If the poll rate of the DX4020
is set to 5 minutes or faster, there is a possibility of excessive data usage that may exceed
your data plan with the cellular service provider. Be sure that any Communication Trouble
events are addressed as soon as possible.
Default: No Device
Selection: No Device, Phone 1..4, SDI ## Path 1..4
Phone 1 Phone 1 is this group’s primary destination.
To Next Page
Loading...
