D9412GV4/D7412GV4/D7212GV4 SDI2 Modules | en 193
Bosch Security Systems, Inc. Program Entry Guide F.01U.218.312 | 04 | 2012.03
press [ENT] when the RF repeater you wish to remove shows. he keypad reads RF
REPEATER REMOVED.
D1260
1. Refer to Section 2.5.1 Keypad Programming Menu, page 12 to access the Tools Menu and
navigate to the RF Repeaters option.
2. Press [ENT] to enter the Remove Repeaters option.
3. At the Repeater 1-8 option, enter the repeater number you wish to remove and press
[ENT] or scroll through the available devices to remove by pressing the Next softkey, and
then press [ENT] when the RF repeater you wish to remove shows. he keypad reads RF
Repeater Removed.
8.5.2 RF Diagnostics Keypad Menu (RFID Wireless Repeaters)
RF Points -- States
D1255
1. Refer to Section 2.5.1 Keypad Programming Menu, page 12 to access the TOOLS MENU
and navigate to the RF DIAGNOSTICS option.
2. Press [ENT] to enter the RF DIAGNOSTICS option.
3. Press [ENT] at the RF POINTS option to enter it.
4. Press [ENT] to enter the STATES option.
5. Press [NEXT]. Within the STATES option, the menu will scroll through the following sub-
categories, with the results of the diagnostic check:
– STATE
–TAMPER
–LOW-BATTERY
–MAINTENANCE
D1260
1. Refer to Section 2.5.1 Keypad Programming Menu, page 12 to access the Tools Menu and
navigate to the RF Diagnostics option.
2. Press [ENTER] to enter the RF Diagnostics option.
3. Press [ENTER] at the RF Points option to enter it.
4. Press [ENTER] to enter the States option.
5. Press the Next softkey. Within the States option, the menu will scroll through the
following sub-categories, with the results of the diagnostic check:
– State
–Tamper
– Low-Battery
– Maintenance
RF Points -- Signal Strengths
D1255
1. Refer to Section 2.5.1 Keypad Programming Menu, page 12 to access the TOOLS MENU
and navigate to the RF DIAGNOSTICS option.
2. Press [ENT] to enter the RF DIAGNOSTICS option.
3. Press [ENT] to enter the SIGNAL STRENGTHS option.
To Next Page
Loading...
