192 en | SDI2 Modules D9412GV4/D7412GV4/D7212GV4
F.01U.218.312 | 04 | 2012.03 Program Entry Guide Bosch Security Systems, Inc.
4. At the Repeater 1-8 option, enter repeater number you wish to configure and press
[ENTER] or scroll through the list of available repeater numbers by pressing the Next
softkey. RFID: Not Assigned shows.
5. Press [ENTER]. The keypad indicates a transmission to the device.
6. Press the RESET button on the repeater to add it. The keypad reads Repeater Added.
Replace Repeater
D1255
1. Refer to Section 2.5.1 Keypad Programming Menu, page 12 to access the TOOLS MENU
and navigate to the RF REPEATERS option.
2. Press [ENT] to enter the RF REPEATERS option.
3. At the REPEATER 1-8 option, enter the repeater number you wish to configure and press
[ENT] or scroll through the available devices to replace, press [NEXT], and then press
[ENT] when the RF repeater you wish to replace shows.
4. If repeaters are available for adding as a replacement, a list of repeaters shows. To scroll
through the available repeaters to add, press [NEXT], and then press [ENT] when the
desired repeater shows.
5. The keypad indicates a transmission to the device. Press the RESET button on the device
to add it. The keypad reads REPEATER ADDED.
D1260
1. Refer to Section 2.5.1 Keypad Programming Menu, page 12 to access the Tools Menu and
navigate to the RF Repeaters option.
2. Press [ENT] to enter the RF Repeaters option.
3. At the Repeater 1-8 option, enter the repeater number you wish to configure and press
[ENTER] or scroll through the available devices to replace, press the Next softkey, and
then press [ENTER] when the RF repeater you wish to replace shows.
4. If repeaters are available for adding as a replacement, a list of repeaters shows. To scroll
through the available repeaters to add, the Next softkey, and then press [ENTER] when
the desired repeater shows.
5. The keypad indicates a transmission to the device. Press the RESET button on the device
to add it. The keypad reads Repeater Added.
Remove Repeater
D1255
1. Refer to Section 2.5.1 Keypad Programming Menu, page 12 to access the TOOLS MENU
and navigate to the RF REPEATERS option.
2. Press [ENT] to enter the REMOVE REPEATERS option.
3. At the REPEATER 1-8 option, enter the repeater number you wish to remove and press
[ENT] or scroll through the available devices to remove by pressing [NEXT], and then
NOTICE!
You must directly enter in a RF Repeater number (2) that has an assigned RFID. Attempting to
enter a repeater, without an assigned RFID will generate error tone.
NOTICE!
You must directly enter in a RF Repeater number (2) that has an assigned RFID. Attempting to
enter a repeater, without an assigned RFID will generate error tone..
To Next Page
Loading...
