D9412GV4/D7412GV4/D7212GV4 Panel and Area Wide Parameters | en 19
Bosch Security Systems, Inc. Program Entry Guide F.01U.218.312 | 04 | 2012.03
4. The Pause (3-sec pause - "C") and DT Detect (Dial Tone Detect - "D") softkeys enter
special characters. The Backspace softkey allows you to erase characters. The Clear
softkey allows you to clear the entire phone number. The [COMMAND] and [ENTER] keys
allow you to enter an * or a #. Use the softkeys, the number buttons, and the
[COMMAND] and [ENTER] keys on the keypad to enter the new phone number.
5. Press the Save softkey.
When the keypad reads Parameter Saved, your selection has been configured.
3.2 Phone Parameters
The program items in this category describe panel wide characteristics for telephone dialing,
receiver format, and supervision.
Phone # Format
Central Station Receiver Format for Transmission of Reports: Modem format provides many
reporting advantages over the Contact ID format. Refer to the D6500 Report Directory (P/N:
74-04651-001) for more information about the effect of reporting formats.
Reports identify points as 001 through 247 and passcode User ID codes as 000 through 999 at
the D6500 or D6600 Receiver (unless Point/User Flag is programmed Yes; refer to
Section Point/User Flag, page 19 in this section). When reporting point events, ModemIIIa
2
Communication Format also sends point text to the D6500 or D6600 as programmed in Point
Assignments.
Keypad Programming of Phone # Format
D1255
1. Refer to Section 2.5.1 Keypad Programming Menu, page 12 to access Keypad Programming
and navigate to the PHONE PARAMETERS option.
2. At the PHONE 1 - 4 prompt, enter the phone route number you wish to configure and
press [ENT].
3. Press [NEXT] or [PREV] to toggle between Contact ID and ModemIIIa
2
and press [ENT] to
select the desired phone format.
When the keypad reads PARAMETER SAVED, your selection has been configured.
D1265
1. Refer to Section 2.5.1 Keypad Programming Menu, page 12 to access Keypad Programming
and navigate to the Phone Parameters option and press the corresponding softkey.
2. At the Phone (1 - 4) prompt, enter the phone route number you wish to configure and
press [ENTER]. The current configuration shows.
3. Press the Edit softkey to change the phone format.
4. Select the softkey for the option you wish to change. Press the Save softkey.
When the keypad reads Parameter Saved, your selection has been configured.
Point/User Flag
Default:
ModemIIIa
2
Selection:
ModemIIIa
2
or Contact ID
ModemIIIa
2
ModemIIIa
2
Communication Format
Contact ID ANSI-SIA Contact ID
Default: No
Selection: Yes or No
To Next Page
Loading...
