66 en | Panel and Area Wide Parameters D9412GV4/D7412GV4/D7212GV4
F.01U.218.312 | 04 | 2012.03 Program Entry Guide Bosch Security Systems, Inc.
Disarming a Shared Area
Shared areas automatically disarm when any associate area in the control panel is disarmed.
Passcode, tokens, cards, key switch, sub-controls, or RPS cannot disarm shared areas.
Shared Area Arming Sequence
When shared areas automatically begin to arm, the arming is based on the A# Exit Dly Time is
based on the A# Exit Dly Time of the Shared Area.
Shared Area Not Ready
If a point is faulted in the shared area, CHK AREA appears on the associate keypad that is
arming the last associate area. Associate area keypads can show faults from shared areas as
long as the shared areas fall within the scope of the associate area.
Force Arming a Shared Area
When CHK AREA appears, press [ESC] to show FORCE ARM at the associate keypad. Pressing
[ENTER] force arms the shared area if:
– the user has authority to bypass points,
– the point is bypassable, and
– the number of faulted points does not exceed the force arm maximum amount for the
shared area.
Viewing Shared Area Armed Status
View Area Status can be used from a keypad outside of the shared area to view the shared
area’s armed state.
Silencing Sounders in the Shared Area
Silence shared area alarms and troubles from any keypad.
To silence sounders, the user needs an authority level assigned to the shared area. If the user
also has the authority to arm or disarm the area, then ALREADY ARMED or ALREADY
DISARMED momentarily appears.
Access Control Readers Assigned to the Shared Area
The shared area restarts the exit delay sequence allowing a user to walk to an associate area
and disarm. If the token or card reader assigned to the shared area includes any associate
area in the D## CC# Scope (in the access control section), both the associate area and shared
area disarms when the token or card is presented. (Refer to Section Access Control Readers
Assigned to the Shared Area, page 66.)
Closing Reports for Shared Areas
If Closing Reports for shared areas are needed, assign passcodes a valid authority level in the
shared area.
3.10.3 Bell Parameters
The D9412GV4 and the D7412GV4 have two main types of annunciation: Fire Bell and Burg
Bell. Both Fire and Burg Bells share the same terminal (Terminal 6) on the control panel as
shipped from the factory.
If a simultaneous Fire Bell and Burg Bell occur, the Fire Bell takes precedence over the Burg
Bell regardless of which relay or terminal output they share.
NOTICE!
Remember to include the shared area in the associate area’s scope.
To Next Page
Loading...
