Bosch D7412GV4 - Tokens and Cards; Reporting and Logging

126 en | Passcodes, Access Credentials, and User Groups D9412GV4/D7412GV4/D7212GV4
F.01U.218.312 | 04 | 2012.03 Program Entry Guide Bosch Security Systems, Inc.
4.1.5 Tokens and Cards
All standard users that can be assigned a passcode can also be assigned a token or card by
programming the U### Site Code and U### Card Data.
4.1.6 Reporting and Logging
The user ID number used in some event reports can be represented differently to
accommodate limitations in technology. Keyfob and access users report as standard users.
Refer to the table below for User ID representation in each situation.
U### Passcode
Enter three to six digits to enable a passcode for the master user in this group.
User ID Type Keypad View
Log
RPS View Log Contact ID
ModemIIIa
2
SDI Bus Printer
(D9131A)
User Text
(Reporting &
Printing)
Service User 0 0 F00 0 0 SERVICE USER
Standard User 1...254
255...999
1...254
255...999
1...254
255...999
1...254
255...999
1...254
Blank
[Configured
text]
Time Sync 5001 5001 F01 5001 Blank AUTO TIME
SYNC
RPS User 5002 5002 F02 5002/Blank Blank BY RPS
Automation
User
5003 5003 F03 5003/Blank Blank BY
AUTOMATION
Keyswitch 5004 5004 F04 5004 Blank BY KEYSWITCH
No User
Specified
Blank Blank 000 Blank Blank Blank
NOTICE!
In reporting systems using ModemIIIa
2
reporting format, all three digits of the User ID Code
are transmitted to the central station with appropriate reports. Central station automation
computer systems can accept only Zonex and Comex style User IDs. Refer to Section Point/
User Flag, page 19.
NOTICE!
User 000 is the Service Authority Level (Level 15). You cannot change the programming for
user 000.
Only the Service Authority Level (User 000) can delete User 000. When a user other than User
000 tries to delete the passcode for User 000, the keypad gives an error tone and prohibits
the operation.
User 000 cannot be added or changed by the Add/Change user command (COMMAND 56)
except by a user with the Service Passcode.
Default: User 001 is 123456, All other user passcodes are Blank.
Selection: Three to six digits ( 0 to 9)
NOTICE!
To meet UL 864 requirements (D9412GV4 and D7412GV4), enter at least one Passcode.