Bosch D7412GV4 - Page 58

58 en | Panel and Area Wide Parameters D9412GV4/D7412GV4/D7212GV4
F.01U.218.312 | 04 | 2012.03 Program Entry Guide Bosch Security Systems, Inc.
Answer Disarmed
Set telephone ring counter to answer when any area is in a perimeter armed or disarmed
state.
RPS Phone #
This is the phone number the control panel dials to contact RPS. Refer to
Section 3.8.1 Uploading and Downloading Reports, page 54 for instructions on configuring
special phone number digits to detect dial-tone detect and to pause dialing. The control panel
dials this number when any of the following events occur:
– Log % Full threshold is achieved.
– The control panel is contacted by RPS and RPS Call Back is programmed Yes.
– The user enters and selects the call RPS option from the menu. On the D1255:
– 1. Press [COMAND][4][3].
– 2. Press [NEXT] until RPS via Phone? appears, then press [ENTER].
Refer to Section 3.5 SDI RPS/Enhanced Communications Configuration, page 45 for other
connection methods.
NOTICE!
For the purposes of answering the RPS phone call, the control panel considers Perimeter
Armed a disarmed state.
Default: 7
Selection: 0 to 15
0
1 to 15 The control panel answers the phone after the specified number of
rings when any area in the system is in a perimeter armed or disarmed
state.
NOTICE!
For the purposes of answering the RPS phone call, the control panel considers Perimeter
Armed a disarmed state.
Default: Blank
Selection: Blank or up to 24 characters
Blank Control panel does not dial a phone number for RPS.
1 to 24 characters Enter up to 24 characters to define dialing characteristics.
NOTICE!
If Log % Full is programmed with a value (1 to 99) and an RPS phone number or RPS IP
address are programmed, the control panel attempts to communicate with Unattended RPS
when the log threshold is reached.
NOTICE!
The control panel tries to contact RPS only once using this method.
NOTICE!
Refer to Section Phone #, page 17 descriptions of special programming values for the RPS
Phone number.