Bosch DS7200V2-EXP - Page 62

DS7200V2-EXP | Installation Guide | 3. Control Panel
Programming
EN | 62
Bosch Security Systems, Inc. | 04/12 | F01U253045-02
3.2.6 Global Open/Close Options
Arming Options 1
• Address: 0258
• Default: 0
• Selections: 0 to 7
Enter This Data Digit to Select Options
Arming Options 1
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
No Options Enabled
•
Enable All On-No Exit
•
•
•
•
Answering Machine Bypass only when All/Perimeter
Only On
•
•
•
•
Remote Arming with Telephone, Area 1
•
•
•
•
Reserved
• Enable All On-No Exit: If this option is enabled and the system is turned All On and no Entry/Exit
zones are faulted during Exit Delay, the system automatically shifts to Perimeter Only. Perimeter
Only (not All On) appears in the log and reports. This option can only be used if the control panel
is armed with delay. This option does not apply when arming with keyswitches or RF keyfobs.
• Answering Machine Bypass Only When All On/Perimeter Only On: If this option is enabled, the
Answering Machine Bypass function is activated at RPS Answer Ring Count, Answering Machine
Bypass parameter (see page 56). If activated there, this option can be used to restrict its function
so that it only operates when the system is All On or Perimeter Only On. The system does not
answer if disarmed.
• Remote Arming with Telephone, Area 1: If enabled, this option controls the built-in telephone
arming feature for Area 1. When enabled, the control panel answers the phone on the ring count
for remote programming. The following occurs when the control panel answers the phone:
- If the control panel is All On or Perimeter Only On, it sounds three beeps and starts the
handshake tone for remote programming.
- If the control panel is Off, it sounds one short beep, waits approximately three sec and then
starts the handshake tone for remote programming (one long beep). Press and hold [5] for
two sec immediately after the first short arming beep and before the handshake tone begins.
If arming from a cell phone, quickly press [5] three times. If pressing and holding [5] for two
sec from a house (landline) phone does not produce a tone long enough to arm Area 1, retry
by quickly pressing [5] three times.
- The control panel arms if it detects a [5] key press from the telephone (All On with Delay,
faulted zones are force-armed like keyswitch arming). The control panel sounds three beeps
(new armed state) and then hangs up.
You cannot use a telephone to disarm the control panel.