40
Performing While Listening to the Rhythm Sound—About the Guide
You can have recording start after a count-in sound is played.
fig.03-110d
No count-in sound plays when recording is started with a MIDI
Start message received from an external MIDI device.
You can have Playback start after a count-in sound is played.
fig.03-111d
• No count-in sound plays when the playback is started with a
MIDI Start message received from an external MIDI device.
• No count-in sound plays when the playback is started with the
RC-50 or an external foot switch with the CC# function set to
“PHRASE 1/2/3 PLY/STP” or “PHRASE 1/2/3 PLAY.”
* You can also change this value with the GUIDE LEVEL knob.
fig.03-120d
Available Settings: OFF, 2–200
You can switch the jacks to which the guide sound is output.
fig.03-100d
You can select the method used to set the guide sound output;
either with the output set as shown above in each individual
patch, or with the system settings, whereby the same output
destination is selected for all patches.
→
“Using the Same Audio Outputs for All Patches (Input/
Phrase 1, 2, 3/Guide Output Select)” (p. 69)
Playing a Count-In When
Recording (Recording Count-In)
Available Settings
Description
OFF
No count-in is played.
1MEAS
Recording starts after a one-measure count-in is
played.
Playing a Count-In for Playback
(Playback Count-In)
Available Settings
Description
OFF
No count-in is played.
1MEAS
Playback starts after a one-measure count-in is
played.
Adjusting the Volume of the Guide
Sound (Guide Level)
Switching the Output for the Guide
Sound (Guide Output Select)
Available Settings
Description
MAIN
Output from the MAIN OUTPUT and PHONES
jacks.
SUB
Output from the SUB OUTPUT jacks.
The sound is not output from the MAIN OUT-
PUT and PHONES jacks.
MAIN+SUB
Output from the MAIN and SUB OUTPUT jacks
and the PHONES jack.
RC-50_e.book 40 ページ ２００９年４月１０日 金曜日 午後１時１７分
To Next Page
Loading...
