Boss RC-50 - Controlling Operations from the RC-50; To Play Performances on External MIDI Devices at the same Tempo as the RC-50 S Tempo; To Transmit Start; To Transmit Stop

76
Controlling Operations from the RC-50
You can play performances on external devices at the same tempo as
the RC-50’s tempo (Synchronized Performance).
MIDI clock messages are output from the RC-50 at all times.Set the
external MIDI device beforehand so it is ready to receive MIDI Clock
and MIDI Start and Stop messages.
For details, refer to the owner’s manual that came with the device.
A MIDI Start message is transmitted at the moment that recording or
playback of the current phrase begins, when all phrases had been
stopped.
This message is also transmitted when an All Start is carried out.
A MIDI Stop message is transmitted when all of the phrases have
stopped. This is also transmitted when All Stop is in effect.
fig.08-130
When patches are switched on the RC-50, a MIDI Program Change
message is transmitted to the connected external MIDI device.
You can transmit Program Change messages numbered 1 through
99,corresponding to the 99 individual patches 1–99.
* Set MIDI Program Change Out (p. 75) to ON beforehand.
* Program Change messages 100–128 cannot be transmitted.
* Bank Select MIDI messages (Control Change #0, #32) cannot be
transmitted.
You can transmit MIDI Control Change messages by operating the
external foot switch connected to the CTL 1,2 PEDAL jack or EXP
pedal connected to the EXP/CTL 3,4 PEDAL jack.
The following Control Change messages are transmitted by the foot
switch and EXP pedal.
* Set MIDI Control Change Out (p. 75) to ON.
Synchronizing Performances on
External Devices to the RC-50
To Play Performances on External MIDI Devices
at the Same Tempo as the RC-50’s Tempo
To Transmit Start
To Transmit Stop
Transmitting Program Changes
Patch Number Program Number
1
1
2 2
3 3
: :
99 99
Playback Playback
Playback Playback
Playback
Playback Playback Playback
Playback
Phrase 1
Phrase 2
Phrase 3
Start
transmitted
Stop
transmitted
Transmitting Control Changes
Pedal
Controller Number
CTL 1 pedal
CC#80
CTL 2 pedal CC#81
EXP pedal CC#7
CTL 3 pedal Not output
CTL 4 pedal Not output
RC-50_e.book 76 ページ ２００９年４月１０日 金曜日 午後１時１７分