Boss RC-50 - Other Patch Settings; Adjusting the Patch Volume; Switching Phrases at the End of the Loop (Phrase Change Mode); Adjusting the Time Used to Fade in (Fade-In Time)

49
Making the Patch Settings
Chapter 4
These procedures are for making other patch settings.
fig.04-160
1. Press [NAME/PATCH] twice.
2. Press PARAMETER [ ] [ ] to display the parameter
you want to set.
fig.04-170d
3. Rotate the PATCH/VALUE dial to adjust the parameter.
4. Repeat Steps 2–3 as needed.
5. When finished making the settings, press [EXIT] to return to
the Play screen.
You can adjust the overall patch volume. This is convenient when
you want to connect an external EXP pedal and use the pedal to
control the volume or adjust the output volume for both the MAIN
OUTPUT and SUB OUTPUT jacks simultaneously.
Normally, this is set to the center with a level of 100.
fig.04-180d
Available Settings: 0–200
You can select the method used for switching patches in Single mode
and Multi mode and switching the current phrase in Single mode
(Phrase Change mode).
fig.04-190d
This adjusts the fade-in time when the phrase is set to fade in upon
playback.
fig.04-210d
Available Settings: 0–100
This procedure adjusts the fade out when playback of a phrase is set
to fade out before stopping.
fig.04-200d
Available Settings: 0–100
Other Patch Settings
32
5 1
(Example)
Adjusting the Patch Volume
Switching Phrases at the End of the
Loop (Phrase Change Mode)
Available Settings
Description
IMMEDIATE
When a switch in patches or the current phrase is
carried out, recording or playback of the next
designated patch or current phrase begins im-
mediately.
LOOP END
When a switch in patches or the current phrase is
carried out, recording or playback of the next
designated patch or phrase begins once the end
of the current phrase (length of the current loop
when Loop Sync is on in Multi mode) is reached.
Adjusting the Time Used to Fade In
(Fade-In Time)
Adjusting the Time Used to Fade
Out (Fade-Out Time)
RC-50_e.book 49 ページ ２００９年４月１０日 金曜日 午後１時１７分