Boss RC-50 - When Loop Sync Is off

59
Examples of the Use of Multi Mode
Chapter 5
When Loop Sync is switched off, each of the phrases plays back repeatedly according to the individual phrase’s length.
Example 1) Recording three blank phrases, one after another, to create an
ensemble when played in real time
fig.05-040
In this manner, using the PHRASE 1, 2, and 3 pedals and REC/PLAY/OVERDUB pedal to switch the current phrase as you proceed with the
recording, you can continue recording one phrase after another while playing back the phrase or phrases recorded thus far.
If Tempo Sync is on for the first phrase recorded (Phrase 1, as an example), you can record later phrases at the same tempo as that of the phrase
recorded first (Loop Quantize; p. 42).
You can record each phrase with a different length, making it convenient for combining loops, each of which is only the length needed; for
example, with a one-measure bass pattern and two-measure riff pattern.
To match recorded lengths in measure units, use Loop Quantize.
→ “Loop Quantize” (p. 42)
Example 2) Repeated playback of desired recorded phrases
fig.05-050
When the phrases are being played back, playback of the phrase begins after the phrase is made the current phrase and the REC/PLAY/
OVERDUB pedal is pressed. This allows you mix effect sounds and instrument performances with timings that are almost inconceivable.
When Loop Sync is Off
Recording Playback Playback Playback
REC/PLAY/
OVERDUB
REC/PLAY/
OVERDUB
REC/PLAY/
OVERDUB
REC/PLAY/
OVERDUB
PHRASE 2 PHRASE 3
Phrase 1
(Current Phrase)
Recording (Current Phrase) Playback
Phrase 2
Recording
(Current Phrase)
Phrase 3
Playback
Playback
Playback
Playback
REC/PLAY/
OVERDUB
REC/PLAY/
OVERDUB
REC/PLAY/
OVERDUB
PHRASE 2 PHRASE 3
Playback
Phrase 1
(Current Phrase)
Playback
Phrase 2
Phrase 3
Playback
Playback
Playback
Playback
Playback(Current Phrase)
(Current Phrase)
RC-50_e.book 59 ページ ２００９年４月１０日 金曜日 午後１時１７分