90
Correspondence Between the Indicators and Operational Status
REC/PLAY/OVERDUB Pedal
Lit (Red)
Current phrase is being recorded.
Lit (Green) Current phrase is being played back.
Lit (Orange) Current phrase is being overdubbed.
Flashing (Red) Current phrase is enabled for recording.
Flashing (Green)
Current phrase is enabled for playback.
Flashing
Rapidly (Red)
Current phrase is enabled for recording and on standby for Auto Recording (p. 47).
Flashing
Rapidly (green)
The current phrase is fading in or out, or the RC-50 is waiting for the end of a loop
with Stop Mode (p. 53) set to LOOP END.
TEMPO Pedal
Off
The TEMPO pedal function (p. 70) is assigned to a function other than PATCH
TEMPO (TAP), or the RC-50 is in Patch Select mode (p. 33).
Flashing
Flashes in time with the current patch’s patch tempo. Flashes red on the downbeat
of the measure, green on other beats.
UNDO/REDO Pedal
Off
Indicates redo cannot be executed. Also, indicates that a function other than Undo/
Redo is assigned.
On Indicates redo can be executed.
PHRASE 1/2/3
Pedal
Orange Indicator
Off Not current phrase.
On Current phrase.
Flashing
When a patch has been selected in advance to be switched, and when a phrase is se-
lected and the RC-50 is set in advance to switch to the current phrase, this indicates
that the current phrase will be active from that point.
Green/Red
Indicators
Off
Not current phrase, and phrase is stopped.
Lit (Red) Current phrase, which is currently recording.
Lit (Green) Phrase is being played back.
Lit (Orange) Current phrase, which is currently being overdubbed.
Flashing (Red)
Indicates in the following cases that recording of the phrase is to begin:
• When phrase is current phrase, and it is stopped
• When a patch is selected and advance patch switching is set (status of patch to
which you are switching)
• When a patch is selected and advance switching to the current phrase is set.
Flashing
(Green)
Indicates in the following cases that playback of the phrase is to begin:
• When phrase is current phrase, and it is stopped
• When Simul-Start is set to ON in the phrase, and all phrases are stopped
• When a patch is selected and advance patch switching is set
• When a patch is selected and advance switching to the current phrase is set.
Flashing
Rapidly (Red)
Indicates Auto Recording (p. 47) standby when the current phrase is enabled for re-
cording and all phrases are stopped.
Flashing
Rapidly (Green)
The phrase is fading in or out, or the RC-50 is waiting for the end of a loop with Stop
Mode (p. 53) set to LOOP END.
RC-50_e.book 90 ページ ２００９年４月１０日 金曜日 午後１時１７分
To Next Page
Loading...
