4 Prearrangement
32 Operating Manual ARC 400 BOWA-IFU-11779-ARC400-V2.1.0-S0-EN
The main screen appears, and the HF device is ready for use.
The parameters of the most recently selected program appear on the
display.
NOTE
Standby mode
The standby mode of the HF device is described as follows:
The power switch 31 on the rear panel of the HF device is switched on
and the front-panel On/Off button 1 is switched on, with the on/off button
1 illuminated orange.
(IEC 60601-2-2:2010 Section 201.11.8)
4.3. Connecting instruments
Before connecting instruments, ensure that the following conditions are
met:
Combinations of accessories not mentioned in the operating
manual may be used only if they are explicitly designed for
the intended use. Always observe performance
characteristics and safety requirements.
The insulation of the accessories (e.g. HF cables and
instruments) must be sufficient for the maximum peak
output voltage (see IEC 60601-2-2 and IEC 60601-2-18).
Do not use accessories with defective insulation.
To Next Page
Loading...
