5 Operation
BOWA-IFU-11779-ARC400-V2.1.0-S0-EN Operating Manual ARC 400 53
5.4.9. Configuring the startup screen
ARC 400 offers the possibility to display a personalized start screen. This
start screen appears after each switching on of the unit for a configurable
period of time.
1. Create a folder with the name "arc_logo" on the USB flash drive
(REF 900-402).
2. Open the Windows program " Notepad.exe " and enter a number
between 5 and 60 for the displayed duration in seconds.
3. Save this file on the USB flash drive in the folder "arc_logo" under the
name "KH_Logo.conf". Make sure that the file is stored as type "All
Files ( *. *)" and encoding "UTF -8".
4. Create a startup screen with a resolution of 800 x 480 pixels and save
it under the name "KH_Logo_arc400.png" in the folder "arc_logo".
5. Plug the USB flash drive with the files created in the USB port of the
ARC 400 and turn the unit on using the main switch.
Make sure that there are no other data on the USB flash drive.
6. Wait until the ARC 400 is fully booted and the user interface appears.
7. To configure the start screen, select Service Level 1 under Menu /
Service (see section 5.10.4).
8. Press the “Add Logo” button to add the start screen.
9. Switch the ARC 400 off and then on to check correct acceptance.
Now your generated startup screen is permanently stored in the device
and appears after every switching-on for the specified duration.
To Next Page
Loading...
