107
Installation & Connection
Installation Procedure
1 To prevent a short circuit, remove the key from the ignition and disconnect the negative
post (-) battery.
2 Make the proper input and output wire connections for each unit.
3 Connect the speaker wires of the wiring harness.
4 Connect the wiring harness wires in the following order: ground, battery, ignition.
5 Connect the wiring harness connector to the unit.
6 Install the unit in your car.
7 Reconnect the negative post (-) battery.
8 Press the hardware reset button.H
WARNING
Do not connect the ignition wire and the battery wire to the car chassis(ground) ,you may cause a
short circuit, that in turn may start a fire. Always connect those wires to the power source running
hrough the fuse box.
Do not cut out the fuse from the ignition wire and the battery wire.
The power supply must be connected to the wires via the fuse.
●
●
CAUTION
If your car's ignition does not have an ACC position, connect the ignition wires to a power source
hat can be turned on and off with the ignition key.
If you connect the ignition wire to a power source with a constant voltage supply, as with battery
wires, the battery may die.
If the console has a lid, make sure to install he unit so that the faceplate will not hit the lid when
closing and opening
If the fuse blows, first make sure the wires aren't touching to cause a short circuit, then replace the
old fuse with one with he same rating.
Insulate unconnected wires wi h vinyl tape or other similar material. To prevent al short circuit, do
not remove the caps on the ends of the unconnected wires or the terminals.
Connect the speaker wires correctly to the terminals to which they correspond. The unit may be
damaged or fail to work if you share the "-" wires or ground hem to any metal part in the car.
When only two speakers are being connected to the system. Connect the connectors either to
both the front output terminals or to both the rear output terminals (do mot mix front and rear).
For example, if you connect the "+" connector of the left speaker to a front ouput terminal, do not
connect the - connector to a rear ouput terminal.
After he unit is installed, check wheather the brake lamps, blinkers, wipers, etc. on the car are
working properly.
Mount the unit so that the mounting angle is 30' or less.
●
●
●
●
●
●
●
●
To Next Page
Loading...