117
Troubleshooting Guide
TROUBLE CORRECTIVE ACTION
No Power
Check that DC power cable is connected properly.
No Picture
1. Make sure that the equipment is connected properly.
2. Check hat he connected monitor is turned on.
Stopped picture
1. Check hat he video cable is connected.
2. Check hat he monitor is turned on.
The playback picture is poor.
Clean he disc.
No color.
Adjust the video system by changing TV output mode
(AUTO, PAL, NTSC)
The remote control doesn't
work properly.
Remove any obstacles between the remote controller and
remote control sensor of the unit. Operate the remote control at
a closer distance to he unit.
ERROR-DISC is displayed on
the screen.
1. Turn the power off, then turn it on.
2. Turn the power off, disconnect the power plug, then
reconnect it.
ERROR-DISC Check Regional
Code is displayed on the
screen.
Check in which redion the DVD Disc can be played.
The DVD Disc is not available of the region code of the DVD
Disc is not in conformity to the one of he unit.
No function with the remote
control.
Check the batteries and make sure that the batteries are fresh &
new, or have enough battery life.
Unable to insert Disc.
1. Check if the protection screw was removed before installation
of the unit. (Only at the first insertion after installation.)
2. Pull out Disc and wait for 3 seconds, and insert Disc again.
No Function With all buttons
on the unit & remote control.
Press the Hard Reset Key.
Check Point.
When a disc is brought from a cold environment to a hot one,
there may be steam on the face of the disc, or water will appear
on he pickup lens. it will affect the play.
1. Remove he disc from he DVD player.
2. Turn on the power and leave it on for an hour to vaporise the
condensation.
Unable to play Bluetooth
Check the user's mobile phone.
Unable to play iPod
Check that the IPOD cable is connected.
To Next Page
Loading...