Braun SpaceStation - Page 57

Disassembly / Assembly SpaceStation
3
SpaceStation, 1.0 gb 3- 15
1.0
9. Pierce two cover caps (Abb.: 3 - 15 / Item 2) with a screw-
driver and pull caps out.
10. Loosen two screws (Abb.: 3 - 15 / Item 1) and remove them
out of the data connector holder.
11. Loosen two screws (Abb.: 3 - 16 / Item 2) and remove them
from the connector board F5 (Abb.: 3 - 16 / Item 1).
12. Press the connector board F5 carefully out of the housing.
Note
The connector board F5 is integrated in the interface board.
Abb.: 3 - 15
Legende zu Abb. 3 - 15:
ItemDesignation
1 Screw EJOT 30x9 WN 5452 TORX 10IP A2
2Cover cap
1
2
Abb.: 3 - 16
Legende zu Abb. 3 - 16:
ItemDesignation
1 Connector board F5
2 Screw EJOT 30x9 WN 5452 TORX 10IP A2
1
2