34
max bridge (span length that triggers support in millimeters), min area (minimum area for a
support column in millimeters), and expand support area beyond the part boundary (in
millimeters). Tick the enable box to include the support structures in the print job.
17. First layer – Set the parameters for the first layer, i.e., the layer height in millimeters, printing
speed for the shell (mm/s), and speed for infill (mm/s), number of first-layer offset brims
(skirt count), and skirt offset from the object in millimeters.
18. Output – Set the speed values for the subsequent layers, i.e., the overall print speed (mm/s),
speed for the outermost shell (finish speed, mm/s), speed for non-print movements (move
speed, mm/s),
19. Advanced – Set the Z hop distance for moving the needle upwards to avoid hitting the object
or leaving “blobs” or scratches on the print surface when moving between layers or objects
(mm).
20. Help window – Prompts a window explaining the available keyboard shortcuts for the slicer.
The help window for the slicer keyboard shortcuts:
NB: If there are more than one print head installed in Brinter
®
One, and the printable object’s
center coordinate on Y-axis is less than 65, the photocuring with the fixed LED module will cause
the print head to detach and attach in every layer in which the curing is enabled. This is to prevent
the current print head from crashing with other print heads in the tool sockets while performing
the curing procedure.
To Next Page
Loading...