55
Slide the bed in its place at the back of the chamber [7].
Plug the power cord [8] into the socket [9] at the back wall of the Brinter
®
.
Plug in an additional power supply [10] into the connector [11] at the back panel of Brinter
®
Switch the power back onto the Brinter
®
by plugging in the power cord. Wait until Brinter
®
is properly
powered up and the axes have been homed. If the Main control tab does not yet show the controls
for the temperature-controlled bed, press F5 to update the user interface.
To Next Page
Loading...