Broadcom Brocade X7-8 - Page 40

X7-8-Install-IG100 Installation Guide Brocade
®
X7-8 Director Hardware Installation Guide
2. Tray, Rear, Mid-Mount, Chassis
5. Use three screws (Item 5) to attach each side of the rear tray to the device (see the following figure).
NOTE
The screw holes in the device walls have pem nuts on the inside surface.
6. Use four screws (Item 5) to attach each side of the front tray to the device
7. Use six screws (Item 5) to attach the lip on each side of the front tray to the lip on the front of the device.
NOTE
Do not use the top or bottom holes of the Brocade mounting bracket because the door will interfere with the
screw heads.
X7-8-Install-IG100
40
Broadcom