Broadcom NetXtreme User Manual

Broadcom NetXtreme Ethernet Adapter • Diagnostic User’s Guide
page 142
Broadcom Confidential and Proprietary
a124b2 -- runs test a1,a2,a4 and b2
Options:
-e run NVRAM verification also
-i run IPSec loopback also
-n<DEC> iteration
-b Skip Bond Id verification
10.126 intrtest
Command: intrtest
Description: Interrupt Test
Syntax: intrtest [iteration]
Options:
-n<DEC> iteration (The default iteration is 1. 0 means run forever.)
10.127 pkttest
Command: pkttest
Description: Perform MAC and/or PHY loopback test. This test will send 100 packets in
incremental length and check for contents of loopbacked packets.
Syntax: pkttest [<iteration>]
Options:
-e run external loopback test
-m run mac loopback test
-n<DEC> iteration (The default iteration is 1. 0 means run forever.)
-p run phy loopback test
10.128 cputest
Command: cputest
Description: TX / RX CPU Test. This test needs an input CPU file in the same location as
b57diag.exe. The default file name is cpu.bin or cpu05.bin unless specified by –f option.

Broadcom NetXtreme Specifications

General

Manufacturer	Broadcom
Product Line	NetXtreme
Category	Adapter
Connector Type	RJ45
Supported OS	Windows, Linux
Features	TCP/IP Offload