Broadcom NetXtreme Ethernet Adapter • Diagnostic User’s Guide
page 94
Broadcom Confidential and Proprietary
10.23 pxeprg
Command: pxeprg
Description: Program PXE firmware into NVRAM. This command reads PXE code from a
file and program into NVRAM
Syntax: pxeprg <filename>
10.24 flshdev
Command: flshdev
Description: Select flash device to access
Syntax: flshdev seeprom | atmelflash | sstflash
10.25 bitbang
Command: bitbang
Description: Generate bitbang pattern to seeprom bus. Enter hex numbers to be written to
seeprom bus. For serial eeprom, use 's' for start, 'p' for stop condition, 'x' with '1..9' specifies
how many residual bits to send. For flash, use 's' for chipSelect, 'p' for cancel chipSelect 'r'
with a number specifies how many bytes to read.
Syntax: bitbang <data>
10.26 seclock
Command: seclock
Description: set NVRAM config1 content value after reset.
Syntax: seclock <32bitNewValue>
10.27 setorture
Command: setorture
Description: NVRAM reset torture test
Syntax: setorture
Options:
-c Continue on Error
-i<DEC> Initial Delay in ms (def=0)
To Next Page
Loading...
Need help?
General
