Broadcom NetXtreme - Dids; Serial; Power; Readbr

Broadcom NetXtreme Ethernet Adapter • Diagnostic User’s Guide
page 171
Broadcom Confidential and Proprietary
Options:
-r<string> Configure root complex device
-e<string> Configure endpoint (Broadcom) device (dut)
-x<DEC> Enable ExtendedSync mode for root complex and endpoint (def=0)
-d Display present ASPM State
-i Ignore all previous ASPM setting after a chip reset
10.213 dids
Command: dids
Description: The feature outputs the following information: PCI DID, VID, SDID & SVID;
MAC address, Firmware revision, PXE, PXESpd, WOL, ASF, MBA, Bond Rev. This
information can be used to verify the setup of a chip after a firmware upgrade.
Syntax: dids
10.214 serial
Command: serial
Description: Compares the serial number to defaults or the provided values. This PCI
capability testing is only applicable to Shasta C stepping (i.e. BCM5752Cx) family.
Syntax: serial <dwordLo> <dwordHi>
10.215 power
Command: power
Description: Verify the power function of PCI capability. This PCI capability testing is only
applicable to Shasta C stepping (i.e. BCM5752Cx) family.
Syntax: power
10.216 readbr
Command: readbr
Description: Read a 32-bit value from bridge's configuration space register address.
Syntax: readbr <register address>