Broadcom NetXtreme - Txcfg; Rxcfg

Broadcom NetXtreme Ethernet Adapter • Diagnostic User’s Guide
page 124
Broadcom Confidential and Proprietary
nicRingSetSdPIdx : 0 nicRingStatusUpdate : 0
nicInterrupts : 0 nicAvoidedInterrupts : 0
nicSendThresholdHit : 0
Phy CRC counter : 0
10.84 txcfg
Command: txcfg
Description: Configure protocol packets for transmission
Syntax: txcfg
Example:
0:> txcfg
1. Source MAC : 10:11:12:13:14:15
2. Destination MAC : 00:01:02:03:04:05
3. Length (14-65535) : 1514
4. Packet Type {Non(0),EthV2(1),802.3(2),SNAP(3)}: Ethernet II
5. Protocol Field {Non(0),IP(1),ARP(2),BRM(3)} : IP
6. Source IP : 10.2.1.1
7. Destination IP : 10.2.1.2
8. IP Protocol Field { UDP(17), TCP(6) } : UDP
80. Source Port : 100
81. Destination Port : 200
9. IP Option Length (32-bit Words) : 0
10. TCP Option Length (32-bit Words) : 0
11. Pattern { As-is(0), Inc(1), Random(2), 0s(3), FFs(4),
AA55(5), 55AA(6),IP_Iden-Inc(7),Load from file(8)
00ff8(9) 00ff16(10), 00ff32(11), 00ff(12)} : Increment (00,01,02
...)
12. IP Checksum Offload{ YES(1), NO(0) } : NO
13. TCP/UDP Checksum Offload { YES(1), NO(0) } : NO
14. TCP/UDP Pseudo Checksum Only { YES(1), NO(0) }: NO
15. Insert VLAN Tag { YES(1), NO(0) } : NO
16. VLAN Tag : 1
17. Random IP header field { YES(1), NO(0) } : NO
18. Random TCP/UDP header field { YES(1), NO(0) } : NO
0. Exit
Enter your choice (option=paramter) ->
10.85 rxcfg
Command: rxcfg
Description Configure RX parameters.
Syntax: rxcfg
Example:
0:> rxcfg
1. Host Loopback { Enable(1), Disable(0) } : Disable
2. Modify Rx Packet { Enable(1), Disable(0) } : Disable
3. Dump Rx Packet { None(1),Hex(2), Decode(3) } : None
4. Dump Rx Length : 64
5. Tx Fragment Length : 1518
6. Tx Flags : 0000