Broadcom NetXtreme Ethernet Adapter • Diagnostic User’s Guide
page 185
Broadcom Confidential and Proprietary
11 ERROR MESSAGES
ERROR ID ERROR NO. ERROR STRING
NO_ERROR 0
ERR_IND_REG_ERR 1 Got XXXX @ XXXX. Expected XXXX
ERR_CHIP_RUNNING 2 Cannot perform task while chip is running
ERR_BAD_NIC 3 Invalid NIC device
ERR_READ_ONLY_CLEAR 4 Read only bit X got changed after writing zero at offset XXXX.
ERR_READ_ONLY_SET 5 Read only bit X got changed after writing one at offset XXXX
ERR_READ_WRITE_NOT_CLEAR 6 R/W bit X did not get cleared after writing zero at offset
XXXX
ERR_READ_WRITE_NOT_SET 7 R/W bit X did not get set after writing one at offset XXXX
ERR_BIST 8 BIST failed
ERR_INTERRUPT 9 Could not generate interrupt
CMD_ABORT 10 Aborted by user
ERR_DMA_TXDATA 11 Tx DMA:Got XXXX @ XXXX. Expected XXXX
ERR_DMA_RXDATA 12 Rx DMA:Got XXXX @ XXXX. Expected XXXX
ERR_TXDMA 13 Tx DMA failed
ERR_RXDMA 14 Rx DMA failed
ERR_MEM 15 Data error, got XXXX at XXXX, expected XXXX
ERR_MEM2 16 Second read error, got XXXX at XXXX, expected XXXX
ERR_EEP_WRITE 17 Failed writing NVRAM at XXXX
ERR_EEP_READ 18 Failed reading NVRAM at XXXX
ERR_EEP_DATA 19 NVRAM data error, got XXXX at XXXX, expected XXXX
ERR_FILE_OPEN 20 Cannot open file <filename>
ERR_BAD_CPU_CFG 21 Invalid CPU image file <filename>
ERR_IMAGE_SIZE 22 Invalid CPU image size XXXX
ERR_MALLOC 23 Cannot allocate memory for size XXXX
ERR_CPU_RESET 24 Cannot reset Rx | Tx CPU
ERR_CPU_NO_RESP 25 Rx | Tx CPU does not respond
ERR_CPU_TEST 26 Rx | Tx CPU test failed
ERR_DMA_RANGE 27 Invalid Test Address Range
Valid NIC address is XXXX- and exclude XXXX-XXXX
ERR_DMA_DATA 28 DMA:Got XXXX @ XXXX. Expected XXXX
SRAM data=XXXX @ XXXX
ERR_PHY_ID 29 Unsupported PhyId XXXX:XXXX
ERR_PHY_TOO_MANY_REG 30 Too many registers specified in the file, max is XXXX
ERR_VPD_WRITE 31 Cannot write to VPD address XXXX
ERR_VPD_DATA 32 VPD data error, got XXXX @ XXXX, expected XXXX
ERR_NO_LINK 33 No good link! Check Loopback plug
ERR_DATA_TX 34 Cannot TX Packet!
ERR_DATA_TX_MISSING 35 Requested to Tx XXXX. Only XXXX is transmitted
ERR_DATA_RX_MISSING 36 Expected XXXX packets. Only XXXX good packet(s) have been
received.
XXXX unknown packets have been received.
XXXX packets have been missing.
ERR_INVALID_TEST 37 XXXX is an invalid Test
ERR_EEPROM_CHECKSUM 38 NVRAM checksum error
ERR_READING_WOL_PXE 39 Error in reading WOL/PXE
ERR_READING_WOL_PXE 40 Error in writing WOL/PXE
ERR_NO_EXT_SRAM 41 No external memory detected
ERR_DMA_LEN 42 DMA buffer XXXX is too large, size must be less than XXXX
ERR_FILE_TOO_BIG 43 File size XXXX is too big, available space is XXXX
ERR_INVALID 44 Invalid <string>
ERR_WRITE 45 Failed writing XXXX to XXXX
CMD_QUIT 46
ERR_CPU_MEM_ERR 47 Rx | Tx CPU access error @ XXXX, expected XXXX but got XXXX
ERR_ENDIF 48
ERR_ROM_D_DATA 49 ROM disable error, data returned while disabled
ERR_CHIP_NOT_RUNNING 50 Cannot perform task while chip is not running. (need driver)
ERR_NO_REG_DEF 51 Cannot open register define file or content is bad
ERR_ASF_RST 52 ASF Reset bit did not self-cleared
ERR_ASF_ATTN_LOC 53 ATTN_LOC XXXX cannot be mapped to Rx | Tx CPU event bit XXXX
ERR_ASF_RST_VAL 54 Register is not cleared to zero after reset
ERR_ASF_PA_TIMER 55 Cannot start poll_ASF Timer
ERR_ASF_PA_CLEAR 56 poll_ASF bit did not get reset after acknowleged
ERR_ADF_NO_STAMP 57 Timestamp Counter is not counding
ERR_ADF_NO_TIMER 58 Timer is not working
ERR_ASF_EVENT 59 Cannot clear bit X in Rx | Tx CPU event register
ERR_EEP_FILESIZE 60 Invalid file size, expected XXXX but only can read
XXXX bytes
ERR_MAGIC_VALUE 61 Invalid magic value in XXXX, expected XXXX but found XXXX
To Next Page
Loading...
Need help?
General
