Broadcom NetXtreme Ethernet Adapter • Diagnostic User’s Guide
page 27
Broadcom Confidential and Proprietary
3.8.5 G5. APE CPU Event Register Test
Command: nictest g5
Function: In this test the APE CPU writes to the APE event registers to verify that each
event state can generate a corresponding interrupt.
Default: Enabled
3.8.6 G6. APE CPU Mutex Register Test
Command: nictest g6
Function: Each of the registers in the APE Mutex Register block is tested from the APE
CPU. This test verifies that each bit set in the Mutex Request register can acquire a
corresponding grant bit in its paired Mutex Grant register. After each grant bit is set it is
written with back to verify the grant bit can be cleared.
Default: Enabled
3.8.7 G7. APE CPU Timers Test
Command: nictest g7
Function: This test each of the APE internal timer registers using the APE CPU. The test
verifies that the timers are functioning and within acceptable tolerances.
Default: Enabled
3.8.8 G8. APE CPU GRC Reset Test
Command: nictest g8
Function: This test verifies that the GRC port interrupt function can be detected via the
APE CPU.
Default: Enabled
3.8.9 G9. APE USB Test (UEFI only)
Command: nictest g9
Function: This test verifies that the APE USB port can be detected from the host controller
by executing a series USB descriptor query commands. This test is only available on the
UEFI version of B57diag.
Default: Disabled
To Next Page
Loading...
Need help?
General
