Broadcom NetXtreme User Manual

Broadcom NetXtreme Ethernet Adapter • Diagnostic User’s Guide
page 56
Broadcom Confidential and Proprietary
8 Special Instruction
1. Mac register test:
Unload MAC driver before running test.
2. Memory test:
Unload MAC driver before running test.
3. DMA test:
Unload MAC driver before running test.
4. TX RX packets:
TX sides need to be configured (txcfg).
RX sides need to be configured (rxcfg).
Configure MAC and PHY loop back.
Call txpkt to transmit packets.
5. The following tests need to setup test configuration before running.
To setup test configuration, run "diagcfg". Diag config can be saved in system for future
use.
Test:
Memory test
NIC test
6. Unload driver before power down NIC card.
7. Load driver after power up NIC card.
8. Blast Test:
Load MAC driver before running test.

Broadcom NetXtreme Specifications

General

Manufacturer	Broadcom
Product Line	NetXtreme
Category	Adapter
Connector Type	RJ45
Supported OS	Windows, Linux
Features	TCP/IP Offload