Broadcom NetXtreme - Eswitchtest; Sbfcfg; Linkintrtest; Ipv6 Extld

Broadcom NetXtreme Ethernet Adapter • Diagnostic User’s Guide
page 180
Broadcom Confidential and Proprietary
Options:
-d Change the port to Docking mode
-l Change the port to Laptop mode
-e Enable E-switch functionality.
-f Disable E-switch functionality. This option will prevent PHY
loopback test, external loopback test (pkttest -e), and carrier test from
being performed on both laptop mode and docking mode. By setting
this option the tests are performed only on the default port.
-m internal engineering manual switch and MAC test
10.239 eswitchtest
Command: eswitchtest
Description: Run E-Switch Timer Test.
Syntax: eswitchtest
Options:
-v verbose
10.240 sbfcfg
Command: sbfcfg
Description: Self-boot file configuration
Syntax: sbfcfg <masterfile> [<upgradefile>]
10.241 linkintrtest
Command: linkintrtest
Description: Link Changed Interrupt Test
Syntax: linkintrtest
10.242 ipv6extld
Command: ipv6extld
Description: Load IPv6 Extension Header File