Broadcom NetXtreme Ethernet Adapter • Diagnostic User’s Guide
page 173
Broadcom Confidential and Proprietary
10.223 pechk
Command: pechk
Description: Check parity error on bridge. Defaults to current bridge.
Syntax: pechk <bridge>
10.224 iscsiprg
Command: iscsiprg
Description: Program ISCSI firmware into NVRAM. This command reads ISCSI code
from a file and program into NVRAM. There are 2 types of ISCSI firmware image. One
only contains ISCSI Boot Firmware. The other also contains ISCSI CFG Block and ISCSI
CFG Program. ISCSI Boot Firmware will be programmed by default. ISCSI CFG Block
will be programmed if either there is no ISCSI CFG Block present in NVRAM or “-c”
option has been entered. ISCSI CFG Program will be programmed only when “-p” option
has been entered.
Syntax: iscsiprg [-f<filename>] [-c] [-p] [-v | -b]
Options:
-f<string> ISCSI firmware file name.
-c Forced to program ISCSI CFG FW
-p Forced to program ISCSI CFG Program.
-v Support IPv6 protocol
-b Support IPv4 and IPv6 protocols
-e Engineering mode, no device check, program the image anyway.
10.225 umpecho
Command: umpecho
Description: Enable/Disable UMP Echo Test function in UMP Firmware. It requires either
ump14a.bin/ump14b.bin test firmware or UMP Firmware. Options that will work with test
firmware are ‘-o’, ‘-c’, ‘-i’ and ‘-a’. Options that will work with UMP firmware are ‘-e’ and
‘-d’.
Syntax: umpecho [-o | -c | -i | -a] | [-e] | [-d]
Options:
To Next Page
Loading...
Need help?
General
