Broadcom NetXtreme User Manual

Broadcom NetXtreme Ethernet Adapter • Diagnostic User’s Guide
page 143
Broadcom Confidential and Proprietary
Syntax: cputest [iteration]
Options:
-r<DEC> CPU reset count (def=1)
-f<string> input filename
-n<DEC> iteration (The default iteration is 1. 0 means run forever)
10.129 dmatest
Command: dmatest
Description: DMA Test
Syntax: dmatest [iteration]
Options:
-4 Allocate 4k-aligned buffers
-a<HEX> NIC address (def=00002100)
-d Display DMA info.
-f Force to use 32-bit bus
-h Test high priority
-l<HEX> Length of DATA to do DMA (def=00000400)
-n<DEC> iteration
-o<HEX> Buffer offset (def=00000000)
-w Test low priority
10.130 teste
Command: teste
Description: The command enables tests. It affects nictest, regtest, pkttest, and memtest
commands. The test must starts with test group alphabet (a-d). If no number is
entered, all tests in that group are enabled.
Syntax: teste [<tests> [<tests>…]]
Example: teste a12bc -- Enable test a1, a2, all tests in group b and c

Broadcom NetXtreme Specifications

General

Manufacturer	Broadcom
Product Line	NetXtreme
Category	Adapter
Connector Type	RJ45
Supported OS	Windows, Linux
Features	TCP/IP Offload

Summary

1 Introduction

2 Prerequisites

OS and Software Requirements

Specifies required OS versions and software executables.

3 Diagnostic Tests

Register, Memory, and Data Tests (Groups A, B, D)

Details tests for registers, memory, and data operations.

APE and Carrier Tests (Groups E, F, G)

Covers APE and physical layer connectivity tests.

4 Command Line Option Parameters

Parameter Descriptions

Explains various command-line options for diagnostics.

10 Test and Functions Description

VPD and NVRAM Configuration Commands

Details VPD and NVRAM configuration commands.

Firmware Upgrade and System Commands

Covers firmware upgrades and system commands.

11 Error Messages