149
Chapter 5 Practical programming examples
Programmer
46. When point Z is programmed, press
ESCESC
twice.
47. Select with , then press .
48. Input the stitch length of needle tacking, then
press .
0.5 mm is input in the example.
Input 005 to make the stitch length to 0.5 mm.
49. Move the needle with . Press when
the needle point is at point A of the pattern
50. Press
ESCESC
twice.
Input the end code
1. Select with , then press .
2. Press .
The needle goes back to the sewing start position and the retractable
clamp is positioned outside.
To Next Page
