V-29
43 MARGIN ADJUST
The position of the top margin and left margin can be confirmed and adjusted within the
range -3.5mm max. and +3.5mm max.
Note:
It is recommended to use the default value in normal use. Do not perform this mode
frequently.
Procedure
Description of Procedures LCD Message
1) Press the Continue button after selecting
Screen (a) “MARGIN ADJUST”.
(a)
→
(b)
2) Using the Set or
▼
button, select either TOP
or LEFT and then press the Continue button.
(b)
→
(c)
3) The margins can be adjusted by up to 3.5mm
left and right in 0.5mm steps from the
reference value “0”.
Using the Set or
▼
button, select the amount
of adjustment by selecting a number
displayed in screen (c) or (d). The amount of
adjustment selected will be displayed at the
upper right corner of Screen (c) or (d).
After confirming the desired amount of
adjustment is displayed, press the Continue
button to set the adjustment.
4) Press the Font button to exit the MARGIN
ADJUST mode. (b)
→
(d)
5) Press the Font button one more time to
return to FACTORY MODE. (e)
→
(f)
39 FACTORY MODE
MARGIN ADJUST
43 MARGIN ADJUST
43 TOP -2.0mm
-<765432101>+
a)
b)
c)
d)
e)
TOP/LEFT/LEFT2
43 TOP +2.5mm
-<101234567>+
43 MARGIN ADJUST
TOP/LEFT/LEFT2
39 FACTORY MODE
DP CHECK
f)
To Next Page
Loading...
