265
POWERHEAD
INSTALLATION
10
Install rear shroud and flywheel cover.
Install the lower engine covers and tighten the
screws.
Connect trim/tilt switch connector.
IMPORTANT: Perform the following procedures
before returning outboard to service:
• Index all spark plugs. Refer to Spark Plug
Indexing on p. 160.
• Use the Evinrude Diagnostics Software pro-
gram to initiate powerhead break-in. Refer to
Powerhead Break-In on p. 109.
• Prime fuel system. Refer to Fuel System Prim-
ing on p. 66.
• Prime oiling system. Refer to Oiling System Oil
Supply Priming on p. 68.
• Adjust timing pointer and check engine timing.
Refer to TIMING ADJUSTMENTS on p. 157.
005248
1. Lower cover screws 005242
1
1
005246
To Next Page
Loading...
Need help?
General
