BWT Perla - 8 Start-up; Installation Check 1;4: Waste Water Connection; Installation Check 2;4: Connection Fitting Ports; Installation Check 3;4: AQA Stop Sensor

22
EN
Installation check 1/4: Waste water connection
according to EN1717
Check that the waste water hoses are connected
properly (see chapter -
18).

Press
INSTALLED .
Installation check 2/4: Ports on the connection
tting
  
-
nected (see chapter 
page 17).
Open the connection fitting by turning the
handwheel anti-clockwise until it stops. Rinsing
of the product starts.

Press
INSTALLED .
Installation check 3/4: AQA Stop Sensor
      
sensor (see chapter   
page 17).

Press
CONFIRM .
Installation check 4/4: Relling the regenerative
Press lightly on the Easy Fill technology cover to
open it (see chapter 
19).
Add up to 30 kg of regenerative (regenerative
tablets in accordance with DIN EN 973 type A) to
the regenerative container. The maximum level

level of approx. 46 cm.
Caution:
Press the Easy Fill technology cover down gently
until it snaps shut.