BWT Perla - 11.5 Functions; 11.5.3 Refilling Operating Materials

49
EN
11.5.3 Relling operating materials
>
Functions > Refill operating materials

The product monitors the regenerative supply with
a sensor and reports a shortfall via the display. All
commonly available regeneratives that comply with
DIN EN 973 type A, can be used.
Press lightly on the Easy Fill technology cover to
open it (see chapter 
19).
-
er. The maximum level of 100% on the display

Caution:
Press the Easy Fill technology cover down gently
until it snaps shut.
NOTE
 When lling the regenerative, make sure
that impurities do not get into the regen-
erative container and locking mechanism
(red circle).
 If necessary, clean the regenerative pack
in advance.
 If you notice impurities in the regenerative
container, clean it with drinking water.
 Overlling past the 100% mark can result
in implausible ll level values being reported.
Remove regenerative in case of overlling.
 The product must not be operated with
Sanitabs or Sanisal.
        

of the product.
Either:
Press
CONFIRM in the Regenerative refilling
window.
Or:
Press
REFILL in the Messages window.

that the regenerative level is being measured (see
chapter 19).