44
EN
11.4.3 Device conguration
Depending on your product and the installed soft-
ware, additional device settings are possible. You
can activate/deactivate these settings as required.
Press the checkbox(es) to activate or deactivate
functions.
AQA Stop Sensor
-
(minimum conductivity of 500 µS/cm).
Acknowledge the message (see chapter
41).
AQA Stop Litre
To minimise water damage, the control valve can
To do so, specify the water volume at which it should
water volume so that your usual water consumption
Press the number to change the water volume.
If the
AQA STOP LITRE
function has been triggered:
Acknowledge the message (see chapter
41).
If a large amount of water is tapped without in-
AQA STOP LITRE
function for a short period of time by deactivating
the checkbox.
To Next Page
Loading...
