Campbell LoggerNet - Page 547

Appendix E. Log Files
TABLE E-1. Transaction Log Messages
User Response to
Code Message Text Message Parameters Message Meaning Message
102 Collect area
skipped
warning
Collect area name The specified collect
area was skipped
because the
associated table has
not been initialized
by the server yet.
During system startup
this is a normal
message. If it occurs at
other times contact an
application engineer.
103 Collect area
skipped error
Collect area name The specified collect
area was skipped
because the server
could not initialize
the associated table.
See message 100
104 BMP1 packet
sent
The packet message type
code:
0 Packet Delivery Fault
Notification
1 Status/Warning/Fault
Notification
2 Network Description
Transaction
3 Clock Check/Set
Transaction
4 Program Down-load
Transaction
5 Program Up-load
Transaction
7 Data Advise Command
Transaction
8 Data Advise Notification
Packet
9 Hole Collection
Command Transaction
10 Control Command (Set
Variable) Transaction
11 User I/O Transaction
(Terminal Mode)
12 Memory Image Down-
load Transaction
13 Memory Image Up-load
Transaction
14 Get Table Definitions
Transaction
15 RF Test Transaction
16 Communication Status
Notification
The specified BMP1
packet was sent to the
serial communication
interface. The
number specifies the
type of message that
was sent.
E-15