Campbell LoggerNet - Page 548

Appendix E. Log Files
TABLE E-1. Transaction Log Messages
User Response to
Code Message Text Message Parameters Message Meaning Message
105 BMP1 packet
received
The packet message type
code:
0 Packet Delivery Fault
Notification
1 Status/Warning/Fault
Notification
2 Network Description
Transaction
3 Clock Check/Set
Transaction
4 Program Down-load
Transaction
5 Program Up-load
Transaction
7 Data Advise Command
Transaction
8 Data Advise Notification
Packet
9 Hole Collection
Command Transaction
10 Control Command (Set
Variable) Transaction
11 User I/O Transaction
(Terminal Mode)
12 Memory Image Down-
load Transaction
13 Memory Image Up-load
Transaction
14 Get Table Definitions
Transaction
15 RF Test Transaction
16 Communication Status
Notification
The specified BMP1
packet was received
over the serial
communications link.
The number indicates
the type of message
received.
106 Data file output
failed
Data collected from a
datalogger could not
be written to the data
output file.
Check that there is
space available on the
hard disk and that write
permissions allow the
server to write the data
output files.
107 Max time on-
line exceeded
The amount of time the
device was connected, in
milliseconds
A client kept the
communication link
on-line longer than
the specified max
time on-line.
E-16