Network Setting
Item Details
Default Setting
RA W Mode Bi-direction Activate this setting to use
Raw mode bidirectional
communication.
Of f
FTP Printing Activate this setting to use FTP
Printing.
On
SMTP Server Address Specify the SMTP server ’ s IP
address.
0.0.0.0
Primary DNS Server Address Specify the IP address of the
primary DNS server .
0.0.0.0
Secondary DNS Server Address Specify the IP address of the
secondary DNS server .
0.0.0.0
DNS Host Name Specify the printer host name,
up to 63 characters (1-63
characters). Use single-byte
letters, numbers, and “-”
(hyphens). Do not use numbers
or “-” for the rst character or “-”
for the last character .
NB-17FBxxxxxxxxxxxx
DNS Domain Name Specify the printer domain
name, up to 63 characters. Use
single-byte letters, numbers, “-”
(hyphens), and “.” (periods). Do
not use numbers, “-” , or “.” for the
rst character , or “-” or “.” for the
last character .
blank
Multicast DNS Service Name Specify the printer ’ s Multicast
DNS service name. (1-63
characters)
This name will be displayed when
Bonjour functions are used.
Canon iPFxxxx (xxxxxx)
7. Click OK to display the Network page.
Note
• If you specify to congure the IP address using DHCP , BOOTP , or RARP , there must be a server that
supports such protocol running in the network.
• If you specify to congure the IP address using DHCP , BOOTP , or RARP , the IP address obtained by this
method is used rst. If you cannot obtain the IP address, the address specied in IP Address is used.
• It takes a minute or two to determine whether DHCP , BOOTP , or RARP are available. W e recommend
clearing check boxes of options you will not use.
• If you are using a DNS server , select Enable DNS Dynamic Update and enter the IP Address for DNS
servers, DNS host name, and DNS domain name in Primary DNS Server Address , Secondary DNS
Server Address , DNS Host Name , and DNS Domain Name , respectively .
546 Network Setting
To Next Page
Loading...
Need help?
General
Weight and Dimensions
