Handling rolls
Specifying the Paper Length
When changing the length of paper after the paper has been advanced, specify the length as follows.
Note
• Specify the paper length when you have set ManageRemainRoll to On . ( → P .126)
1. On the T ab Selection screen of the Control Panel , press ◄ or ► to select the Paper tab ( ).
Note
• If the T ab Selection screen is not displayed, press the Menu button.
2. Press the OK button.
The Paper Menu is displayed.
3. Press ▲ or ▼ to select Chg. Paper Size , and then press the OK button.
4. Press ▲ or ▼ to select Roll Length , and then press the OK button.
5. Press ▲ or ▼ to select the length of paper loaded in the printer , and then press the OK button.
Specify the roll length as follows.
1. Press the ◄ or ► button to move to the next eld for input.
2. Press the ▲ or ▼ button to enter the value.
3. Repeat steps 1 and 2 to nish entering the value, and then press the OK button.
1 12 Handling Paper