Messages regarding paper
Roll printing is selected, but sheets are loaded.
Cause Corrective Action
Follow these steps to load and print on a roll.
1. Press ▲ or ▼ to select Eject Cut Sheet , press
the OK button, and remove the sheet.
( → P .144)
2. Load a new roll.
( → P .106)
The printer now starts printing the print job.
A print job for rolls was received when a sheet is
loaded.
Press ▲ or ▼ to select Stop Printing , and then
press the OK button.
The roll is empty .
Cause Corrective Action
The roll is empty . Follow these steps to replace the used roll with a new
roll of the same type and size.
1. Press the Release Lever back and remove the roll.
( → P .1 16)
( → P .1 18)
2. Load the new roll.
( → P .103)
( → P .106)
3. If no barcode was printed on the roll, specify the
type of paper .
( → P .1 10)
4. When you have selected ManageRemainRoll >
On in the control panel menu and a barcode is not
printed on the roll, also specify the paper length.
( → P .1 12)
5. If Not nished printing. Finish printing
remaining jobs? is shown on the Display Screen ,
press the OK button.
Printing will resume, starting from the page on
which the error occurred.
There is remaining roll paper , but because it could
not be advanced, it could not be detected.
Choose a higher level of Print Quality in the
Advanced Settings of the printer driver .
( → P .187)
Error Message 695
To Next Page
Loading...
Need help?
General
Weight and Dimensions
