Network Setting (Windows)
Specifying the frame type using the printer Control Panel
1. On the T ab Selection screen of the Control Panel , press ◄ or ► to select the Settings/Adj.
tab ( ).
Note
• If the T ab Selection screen is not displayed, press the Menu button.
2. Press the OK button.
The Set./Adj. Menu is displayed.
3. Press ▲ or ▼ to select Interface Setup , and then press the OK button.
4. Press ▲ or ▼ to select NetW are , and then press the OK button.
5. Press ▲ or ▼ to select NetW are , and then press the OK button.
6. Press ▲ or ▼ to select On , and then press the OK button.
The display reverts to the NetW are menu.
7. Press ▲ or ▼ to select Frame T ype , and then press the OK button.
8. Press ▲ or ▼ to select the frame type to use, and then press the OK button.
The display reverts to the NetW are menu.
9. Press ▲ or ▼ to select Print Service , and then press the OK button.
10. Press ▲ or ▼ to select the desired print service, and then press the OK button.
The display reverts to the NetW are menu.
1 1. Press the Menu button.
If any of the settings is changed, a conrmation message is displayed. In this case, press
the OK button.
Important
• Be sure to complete step 1 1. This will activate the values you have entered.
Note
• If an error message is displayed, check the settings and correct any invalid values.
• T o cancel this process, press the Stop button.
Network Setting 587