Messages regarding paper
Insufcient paper for job
Cause Corrective Action
Press ▲ or ▼ to select Print , and then press the OK
button to resume printing.
However , the roll paper may run out during the
print job and you may not be able to print all of the
document.
The printer has received a print job longer than the
amount of roll paper left when ManageRemainRoll
in the Control Panel menu is On .
Press ▲ or ▼ to select Change Paper , and then
press the OK button to stop printing.
Either change the printer driver Paper Source setting
or the GL2 Settings > Paper Source setting in the
printer menu or replace the roll with a roll that has
enough paper for the print job, and then try printing
again.
( → P .1 16)
( → P .106)
This paper cannot be used.
Cause Corrective Action
Paper smaller than the printer ’ s minimum supported
size has been loaded.
Push the Release Lever back and load paper of the
correct size.
( → P .100)
Paper has been loaded that is too small to print
the test pattern for printhead adjustment or nozzle
checking.
Push the Release Lever back and load unused paper
of A4 size or larger . More than one sheet may be
required depending on the adjustment.
Roll printing is selected.
Cause Corrective Action
Press ▲ or ▼ to select Load Roll Paper , and then
press the OK button. Load the roll, and then print.
( → P .103)
( → P .106)
Y ou have attempted to print a test print sheet or
other printer status information on a roll, but no roll
is loaded.
T o print on sheets, follow these steps.
1. Press ▲ or ▼ to select Stop Printing , and then
press the OK button to stop printing.
2. Load a sheet and try printing again.
( → P .81)
694 Error Message
To Next Page
Loading...
Need help?
General
Weight and Dimensions
